COMPARTMENT SYSTEM LIGHTING COMPLETE LED LAMP TYPE ILV24-s

Mean features

  • Lamps Low voltage (24Vcc)
  • Connections Pre-wired connectors "fast"
  • Low power consumption, 2.8 W lamp
  • No hot spot, even the lamps are "cold"
  • The lamp support, separate from the lamp
  • Long life cycle
technical sheet

NOTE:  the only variables in this kit are the number of lamps and the type of power supply to use.

COMPONENTS SUPPLIED IN THE KIT

LED lamp ILV24-s, inclusive of cable (4 meters) of connection to the lamp next. Screws for fixing the lamp and cable.

Switch with box, power cable (2 meters) and connection cable to the first lamp
(2 meters). Fixing screws for switch box and fixing screws for cable -  ( switch room machine).

With switch box and connection cable to the first lamp (2 meters). Fixing screws for switch box and fixing screws for cable .

ALIMENTATORE   versione 230Vac / 24Vcc
Cod.  AL25         =       sino a nr°8 lampade ILV24-s   
Cod.  AL75         =       da nr°9 a nr°22 lampade ILV24-s 

 

AL25

AL75

total lenght

92 mm

144 mm

width 

51 mm

98 mm

height

28 mm

38 mm

Example of  connection

The arrangement of the lamps in the compartment is indicative. Adjust the number of lamps and illumination measured in relation to the luminous flux necessary.

 

Indication to check the led-lamp.

 

  • Use a screwdriver to separate the lamp, from the wall bearing.
  • Once separated, the two pieces appear like this. Bearing on the left and the lamp on the right.

  • Mark the position of the bearing holes on the wall using a pencil.

  • When you have fixed the bearing, fasten the lamp. Push it on the side, just as it is shown, pay attention to the point of anchorage.
  • DO NOT PUSH THE LAMP PRESSING THE TRASPARENT PLEXIGLASS.
  • Attention , fasten the lamp to the bearing, keeping the electric connectors on the correct side of the lamp.
  • The electric connection will be done throught provided “fast-connector” , placed on the side of the lamp. The connector wiring is included in the kit . the connector is polarized according to the wiring.

Technical indication.

Mechanical total dimension, support + lamp

107 x 165  h 45 (mm)

Alimentation range

22Vcc … 28Vcc
Consumpion 120 mA
Tipical Luminuos  intensity 75 cd